This is much easier when taping the wires individually to the 1/8 inch metal rod and pushing
through. Once all wires are on the
other side of the firewall you will
need to cut the wires to length and
put new phone jack connectors on.
(Suggested replacement plugs and
the cut / crimper part numbers and
suppliers are noted on the
attached work instruction) Plug the
shifter wires into the supplied “Y”
connector and plug the Y-
connector and radar receiver into
the proper interface location.
Rear Laser Shifter: The Rear Laser Shifter is (Code letter G on the installation manual)
mounted to the rear license plate. Using a
factory supplied square hole and the
same 1/8 inch metal rod as before cut the
phone jack connector off and run wire
towards the factory rubber boot located on
the right side of the trunk area. You will
need to remove the carpet cover from the
rear panel on the right side on the back.
Use the same method as the front shifters
and run the wire thru the rubber boot. Run
the wire towards the front passenger side to the interface, cut the wire to length, attach a
new modular plug and plug the rear laser into the correct interface location.
Rear Laser Shifter properly installed -