®
to signal the opening of the chamber door, connect to the input D1 of the wireless sensor, a
two core cable with a thickness of min. 0.5mm2, the limit sensor should be installed in the
door. When the door is opened, the limit switch contacts close or open and sends the status
change
signal to the recorder. The door alarm configuration is available in the service menu. The door
limit switch is available as an accessory. The sensor cables do not require polarity of the wires
The signaling of door opening is to consist only in shorting or opening the digital input circuit
D1, not on transferring voltage! When using this input for signaling aggregate operation or
defrost cycles, special care should be taken to ensure that no signaling circuit is energized
Display
3
1
1
2
4
5
printer compartment with space for thermal paper
2
micro USB port for data transfer
3
power socket
4
Service socket (not used)
5
The kit includes a roll of thermal paper that must be installed in the
printer. Thermal paper used for printing is standard and available at
points of sale with paper products. It is recommended to use rollers
with a width of 57 mm and a diameter of 35 mm.
Paper installation method:
1. open the printer cover
(grab in places marked with arrows)
place a roll of paper in the printer compartment
(right part of the thermal paper) and pull it out
about 3 cm of paper over serrated printer's knife
close the printer door by controlling to make paper
he left the printer correctly
tear off the protruding end of the paper using the casing mounted on it
serrated cutting knife
2.
3.
4.
Thermal paper is "singlesided" and must be correctly installed in the printer. If, after starting
printing, the printout is invisible, install the paper so that it unwinds from the other side.
10
