17.
Attach other end of linkages #4 to OUTSIDE
of U-support #7 with bolts #14 and plastic
washers #24. Then slide name panel #5
onto the same bolts #14 on the
INSIDE
of
U-support #7. Secure with lock nuts #15 See
Figure 7B
. Tighten hardware until snug but
do not overtighten. Tubes must pivot freely.
18.
Attach bottom of name panel #5 to
U-supports #7. Secure with hex
bolts #9 and locknuts #15. Tighten
nuts but be careful not to crush
tubes. See
Figure 7B
.
20.
Prepare an area for the assembly of the second table top half. If necessary,
move the first table top half aside with the aid of a helper. Be sure to place it
in a location where it won't be disturbed or damaged. If setting on its side, be
Figure 3
Figure 3
Figure 7B
First Table Top
9
AT LEAST TWO ADULTS ARE NEEDED
TO MOVE TABLE HALF!
CAUTION:
9
14
1/4-20 x 1 1/2” Bolt
(
Qty. 2
)
24
Plastic Washer
(
Qty. 2
)
15
¼” Locknut
(
Qty. 8
)
Hardware Needed
sure to place the bottom edge no less than 12 inches away form the wall. Also
be sure to place carpet or pieces of the shipping carton down to protect table
top edges. If floor is not carpeted, brace table top half with a heavy object to
keep it from sliding.
1/4-20 x 2” Bolt
(
Qty. 2
)
18
15
32
15
24
14
9
9
14
24
15
32
5
15
7
4
7
19.
Attach bottom board #18 to name
panels #5, as shown in
Figure 7B
, using
four bolts #32 and four hex nuts #15.
1/4-20 x 1-1/4” Bolt
(
Qty. 4
)
