ESCALADE B2304W, Руководство пользователя

Страница: 5 / 10

5
IMPORTANT! Nylon washers (#5) adequately space
painted parts at all pivot points. Neglecting the use
of these washers will result in rusted parts.
NOTE: All board arms are made of rectangular tubing.
Tightening hardware too tight may damage tubing
and make adjustment of system difficult.
1. Slide Right Post Ear (#44) and Left Post Ear (#45) behind
bracket on back of Post Assembly (#2). Using allen wrench
(#46) provided, secure Right & Left Post Ears to bracket
using one Flat Head Bolt (#21), one flatwasher (#26) and
one locknut (#33). See Figure 3.
2. Slide Actuator Sleeve (#15) over Actuator (#16) and place
Actuator Cap (#13) on top. Slide Pivot Tube (#14) in hole
near the top of Actuator until equal amounts stick out on
both sides of Actuator. See Figure 4.
NOTE: If necessary, use a hammer or rubber mallet
to tap in Spacer.
ASSEMBLY INSTRUCTIONS (Day 5)
Figure 4
3. Lay Pole (#2) on its side on two padded saw horses. Secure
Actuator (#16) to Pole (#2) using one bolt (#19), split
lockwasher (#18), washer (#3) and two plastic washers (#5)
to thread into each side of Actuator. See Figure 4. Tighten
bolts tight.
4. Insert Pole Cap (#1) into top of Pole (#2). It may be necessary
to use a hammer or rubber mallet to tap Cap in.
5. Secure two stop spacers (#10) to pole, as shown in Figure
4, using one hex bolt (#7) and one hex nut (#4).
Figure 5
Figure 3
6. Attach lower arms (#11) to Pole (#2), as shown in Figure
5, using a bolt (#7), two flatwashers (#3), six plastic washers
(#5), two spacers (#8) and hex nut (#4). Do NOT tighten
bolt (#7) at this time.
Note: make sure "Goalrilla lettering is right side up.