esatto.house
07
INSTALL INLET PIPE
1. Connect the elbow to tap and fasten it clockwise.
2. Connect the other end of inlet pipe to the inlet valve at
the backside of washing machine and fasten the pipe
tightly clockwise. Notes: after connection, if there is
any leakage with hose, then repeat the steps to connect
inlet pipe. The most common type of tap shall be used
to supply water. If tap is square or too big, then standard
tap shall be changed.
→
HOLE PLUG
This Hole plug is used to jam the hole on the back cabinet.
→
PLACE OUTLET HOSE
There are two ways to place the end of outlet hose:
1. Put it beside the water trough.
→
2. Connect it to the branch drain pipe of the trough.
→
Max.100cm
Min.60c
m
Position outlet hose properly so that the floor will not be
damaged by water leakage.
NOTE:
If the machine has outlet hose support, please install it like
the following pictures.
1.
→ When installing outlet hose, fix it properly with a rope.
→ Position outlet hose properly so that the floor will not be
damaged by water leakage.
2.
Trough
Hose Retainer
Bind
Max.100cm
Min.60cm
Min
.60c
m
Ma
x.100c
m
→ If outlet hose is too long, do not force it into washing
machine as it will cause abnormal noises.
ELECTRICAL CONNECTION
As the maximum current through the unit is 10A when you
are using its heating function, please make sure the power
supply system (current, power voltage and wire) at your
home can meet the normal loading requirements of the
electrical appliances.
→ Please connect the power to a socket which is correctly
installed and properly earthed.
→ Make sure the power voltage at your place is same to
that in the machine’s rating label.
→ Power plug must match the socket and cabinet must be
properly and effectively earthed.
→ Do not use multi-purpose plug or socket as extension
cord.
→ Do not connect and pull out plug with wet hand.
→ When connecting and pulling out the plug, hold the
plug tightly and then pull it out. Do not pull power cord
forcibly.
→ If power cord is damaged or has any sign of being
broken, special power cord must be selected or
purchased from its manufacturer or service center for
replacement.
