ESAB MobileFeed 300 AVS, Инструкция по эксплуатации

Страница: 30 / 52

30
sectIon 3 operatIon
3.3 changIng Meter DIsplaY - IpM to MpM
WarnIng
to preVent accIDental electrIc shocK, Be
sure control caBle Is DIsconnecteD froM
poWer source Before WorKIng InsIDe the
WIre feeDer.
1. Make sure control cable is removed from the power
source.
2. Remove meter panel from front panel of the wire
feeder. Retain mounting screws.
3. Check the setting of the “dip switches” on the digital
meter board. These switches can be set up for meter
to read in inches per minute (IPM) or in meters per
minute (MPM) as shown below. The meter is factory
set in IPM positions.
Set the switch on the digital meter to the desired mode
of operation. If the IPM mode is selected, the meter will
read the PRE-SET wire speed when not feeding wire and
the ACTUAL wire speed when feeding wire. If the VOLTS
mode is selected, the meter will only read the ACTUAL
voltage.
DIGITAL METER
PC BOARD
DIGITAL METER
DIP SWITCHES
1
2 1
2
SW1 SW1
Wire Speed IPM Wire Speed MPM
Rocker
Down
Rocker
Down
O
P
E
N
O
P
E
N