ESAB Heliarc 281iAC/DC, Руководство по эксплуатации

Страница: 31 / 48

31
section 5 operation
5. front panel Description and parameters (con't.)
17. Remote Control Button - This button sets the remote control function. The Display A shows the maximum
current. By pressing the button the LED is blinking and adjust the minimum current. The Display V shows
MIN and Display A the value from 0-100 Amp. Adjust the values with the Amper Knob (14). Press the but-
ton for three seconds to deactivate Remote Control mode.
18. LED Remote - The LED is lit when the remote is on and is blinking when the minimum current is adjusted.
19. Select Mode Button - This button selects the welding modes.
20. GTAW Tig 4 Stroke / Repeat - With this function the operator can change from the main set current to the
base current values by pressing the torch trigger quickly.
21. Spot Time Welding - With this function the operator decide a certain time of welding. The Display A shows
the time. The Amper Knob (14) changes the time. The amperage is the one set in GTAW Tig mode.
22. GTAW Tig 4T Mode
23. GTAW Tig 2t Mode
24. SMAW Stick Mode - On stick mode the Arc-Force and Hot-Start are adjustable. By pressing the button
select mode (19) enter in a sub-menu to adjust Arc-Force (0-50%) and Hot Start (0-50%) with the Amper
knob (14).
6. additional features
a) GTAW Tig Hot-Start in AC Mode - It is possible to adjust the Hot-start in AC welding from 0-35% of the
Welding Current. In any of the Tig modes (20,21,22,23) by pressing the Select Mode button (19) enter in a
sub-men to adjust the Hot-Start.
b) Welding Programs - The Heliarc allows to store 60 welding programs.
Storing programs:
1. Press both Prg Mode Enter/Exit buttons (pulse and gas buttons) (10,11).
2. Select your program from 1 to 60 using the Main Control Knob.
3. Press and hold the Store Prg. button (base/final current) (12) until Unit signals with 1 beep, pause,
then 4 beeps. Prg is stored and Exits to Stand by mode.
Recalling the welding programs:
1. Press both Prg Mode Enter/Exit buttons (pulse and gas buttons) (10,11).
2. Select the program you want to recall.
3. Press the Set Prg. button for 3 seconds (slope down) (13).
4. Unit signals with 1 beep, short pause, then 1 beep signaling prg. has been recalled.
with all parameters previously set on that program.