ESAB CIGWELD Transmig 255i, Руководство по эксплуатации, Страница: 67 / 96

OPERATING MANUAL
Transmig 220i
Transmig 255i Transmig 255i
Manual 0-5550 7-1 MANUAL ARC (MMAW) WELDING
SECTION 7:
MANUAL ARC (MMAW) WELDING
7.01 Setup for STICK (MMAW) Welding
A. Connect the Electrode Holder lead to the positive welding terminal (+). If in doubt, consult the electrode
manufacturer. Welding current flows from the Power Source via Dinse type terminals. It is essential,
however, that the male plug is inserted and turned securely to achieve a sound electrical connection.
B. Connect the work lead to the negative welding terminal (-). If in doubt, consult the electrode manufacturer.
Welding current flows from the power source via Dinse type terminals. It is essential, however, that the
male plug is inserted and turned securely to achieve a sound electrical connection.
C. Select STICK mode with the process selection control (refer to Section 4.02.13 for further information).
WARNING
Before connecting the work clamp to the work make sure the mains power supply is switched off.
!
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding Power
Source.
Positive Welding
Terminal (+)
Negative Welding
Terminal (-)
Work Lead
Electrode Holder
Art # A-13934
240VAC
15A Mains Supply
Note: For maximum duty cycle to be achieved,
Supply Plug and Lead must be upgraded to
4mm
2 Supply Lead & 25A Supply Plug.
Refer to Specification Table on Page 2-5.
Figure 7-1: Setup for Manual Arc Welding