ESAB Caddyt Tig 150i, Инструкция по эксплуатации

Страница: 6 / 20

-- 6 --
bt26d2e
4.1 Parameter setting
Settings Setting range In steps of: Default value
Welding method TIG or MMA -- TIG
2/4--stroke 2 stroke or 4 stroke -- 2--stroke
HF / Lift Arc
t
HF or LiftArc
t
-- HF
Slope down time 0--10 s 0.1 s 1.0 s
Gas post--flow 0--25 s 0.1 s 2.0 s
Current TIG Tig 150I 3 -- 150 A 1 A 100 A
Current TIG Tig 200I 3 -- 200 A 1 A 100 A
Current MMA Tig 150I 3 -- 150 A 1 A 60 A
Current MMA Tig 200I 4 -- 150 A 2 A 100 A
5 INSTALLATION
The installation must be executed by a professional.
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user’s responsibility to take adequate precautions.
Note!
Connect the power source to the electricity mains with a network impedance of 0.210 ohm or lower. If the
network impedance is higher, there is a risk of flicker in the illuminators.
5.1 Placing
Place the power source so that its cooling air inlets and outlets are not obstructed.
5.2 Rating plate
The rating plate is located on the underside of the power source or on the rear plate.
GB