ESAB Aristo W82, Инструкция по эксплуатации

Страница: 7 / 24

2 INTRODUCTION
0460 971 301
- 7 -
© ESAB AB 2016
2 INTRODUCTION
Aristo® W8
2
W8
2
is a control unit that enables communication between welding
equipment and automation equipment, such as robots and
computers. Communication protocols: DeviceNet, Profibus,
CANopen and Ethernet.
W8
2
is used together with ESAB CANbus equipped power sources
for welding automation. For power source and wire feed unit
handling, see the relevant instruction manual.
Retrofit Mig 4004i WeldCloud™
Retrofit Mig 4004i WeldCloud™ is retrofitted on top of supported
ESAB power sources. It connects to the CANbus internally.
Communication protocol: WeldCloud™.
There are two versions of Retrofit Mig 4004i WeldCloud™ available,
with different functionality. The available versions have ordering
numbers 0445 302 880 (without connection for ethernet and
communication with robot system) and 0445 302 881 (with
connection for ethernet and communication with robot system).
For information about supported power sources, contact your ESAB
sales representative.
2.1 Equipment
Aristo® W8
2
• W8
2
DeviceNet, W8
2
Profibus, W8
2
CANopen and W8
2
Ethernet are supplied with a
USB memory and an instruction manual.
• W8
2
Integrated is supplied with an instruction manual.
Retrofit Mig 4004i WeldCloud™
• Retrofit Mig 4004i WeldCloud™ is supplied with the software WeldCloud™ and a
Quick start guide.
Measurement cable kit and connection cables for different power sources are available as
accessories, see "ACCESSORIES" chapter and separate spare parts list.