ESAB Aristo Mig C3000i, Инструкция по эксплуатации

Страница: 16 / 28

5 OPERATION
0459 825 301 - 16 - © ESAB AB 2018
5.6 Replacing and inserting wire
• Open the side panel.
• Disconnect the pressure sensor by folding it backwards, the pressure rollers slide up.
• Straighten out the new wire 10-20 cm. File away burrs and sharp edges from the end of
the wire before inserting it into the wire feed unit.
• Make sure that the wire goes properly into the feed roller's track and into the outlet
nozzle and the wire guide.
• Secure the pressure sensor.
• Close the side panel.
5.7 Changing feed rollers
• Open the side panel.
• Disconnect the pressure sensor (1) by folding it
backwards, the pressure rollers slide up.
• Disconnect the pressure rollers (2) by turning the axle
(3) 1/4 turn clockwise and pulling out the axle. The
pressure rollers disconnect.
• Disconnect the feed rollers (4) by unscrewing the nuts
(5) and pulling out the rollers.
During installation, repeat the above in the reverse order.
Choice of tracks in the feed rollers
Turn the feed roller with the dimensioning mark for the required track towards you.