ESAB 653 cvcc, Инструкция по эксплуатации

Страница: 25 / 54

25
SECTION 3 INSTALLATION
The output connections are located on the front panel (Figure 3-5). The negative connection is located at the bottom right
corner and the positive (high inductance and low inductance) connections are located at the bottom left corner. Table 3-2
provides the recommended cable output sizes.
3.5 CONTROL CONNECTIONS
The wire feeder receptacle and 115 VAC Auxiliary control are mounted on a removable plate. This plate may be exchanged
for different applications.
Optional Available Plates:
• Blank (P/N 37902M)
• Terminal Block for Lincoln - 24vac & 115vac feeders - (P/N 0558001416)
• Miller 14 pin Receptacle for 24vac feeders only - (P/N 0558001415)
Refer to Figure 3-5.
Table 3-2. Output Cable Sizes (Secondary)
* Total cable length includes work and electrode cables. Cable size is based on direct current, insulated copper conductors, 100-percent duty cycle
and a voltage drop of 4 or less volts. The welding cable insulator must have a voltage rating that is high enough to withstand the open circuit volt-
age of the power source.
BEFORE MAKING ANY CONNECTIONS TO THE POWER SOURCE OUT
PUT TERMINALS, MAKE SURE THAT ALL PRIMARY INPUT POWER TO
THE MACHINE IS OFF.
3.4 OUTPUT WELDING CONNECTIONS (SECONDARY)
WARNING
Welding
Current
Total Length (Feet) of Cable in Weld Circuit*
50 100 150 20 250
100 6 4 3 2 1/0
150 4 3 1 1/0 2/0
200 3 1 1/0 2/0 3/0
250 2 1/0 2/0 3/0 4/0
300 1 2/0 3/0 4/0 4/0
400 2/0 3/0 4/0 4/0 2-2/0
500 3/0 3/0 4/0 2-2/0 2-3/0