8
If the MAX MIN message is flashing, the instrument is in MAX/MIN
mode but not recording. Press the MAX/MIN button to select a
mode.
To return to normal AUTO measurement mode, hold down the
MAX/MIN button for 2 seconds.
PEAK BUTTON
The Peak Hold function captures the peak AC or DC voltage or
current. The meter can capture negative or positive peaks as fast as
1 millisecond in duration.
Set the function switch to the Amps or Volts.
Press and Hold the PEAK button until “CAL” appears in the display.
This procedure will zero the range selected & the meter will go into
manual ranging mode.
Press the PEAK button, Pmax will display.The display will update
each time a higher positive peak occurs.
Press the PEAK button again, Pmin will display. The display will now
update and indicate the lowest negative peak.
To return to normal operation, press and hold the PEAK button until
the Pmin or Pmax indicator switches off.
Note: If the Function switch position is changed after a calibration the
Peak Hold calibration must be repeated for the new function selected.
The relative change feature allows you to make measurements
relative to a stored reference value. A reference Voltage, Current,
etc., is stored and measurements are made in comparison to that
value. The displayed value is the difference between the reference
value and the measured value.
BACKLIGHT BUTTON
Press the BACKLIGHT button to turn on the display back lighting.
Press BACKLIGHT button again to exit the back light mode.