10
OPERATING INSTRUCTIONS
.
Operation
1. With the operator in the operating position, start
the engine.
2. For proper operation of the attachment
,
try to
approach the stump from a position that will
allow the loader to sit as level as possible.
Remember to position the grinder so that wood
chips and debris will be thrown in a safe
direction.
3. Swing the attachment
all the way to the right
side.
4. Position the loader so the attachment is on the
far right side of the stump. Lift the attachment
slightly above and to the right from the far side
of the stump.
5. Fully lower the
loader’s boom arms and use the
loader’s tilt to get the pivot arm plum, this will
ensure the grinder cuts level.
6. Engage the hydraulics on the loader, increase
the throttle to maximum speed, and using the
controls, lower the cutting wheel into the stump.
NOTE:
Rate of cut will be determined by the
condition of the teeth, type of tree, and
condition the stump is in.
NOTE:
Only cut approximately 1 to 2 inches of
stump depth at a time.
IMPORTANT:
Do not move backward into the
stump while the grinder arm is in motion. Doing
so may result in vibration and/or damage to the
motor.
1 to 2 inches
First Cut
Direction of Loader
travel between cuts
