Erskine Attachments 3S, Руководство оператора

Страница: 10 / 40

10
OPERATING OPTIONAL ELECTRIC CONTROLS
The tree spade can be run using optional wired or wireless electric controls. When using electric controls, mount
the tree s
pade using the “USER’S MOUNTING INSTRUCTIONS” on pages 8-9, then follow the instructions below.
1. Connect the wire harness
to the loader’s 12V
receptacle.
NOTE: The 12V receptacle is not mounted on
the loader lift arms. The distance between the
12V socket and the valve will change when the
loader lift arms are raised. Be sure there is
sufficient slack when lifting the tree spade.
Check the harness slack through the entire full
range of intended motion before operating.
2. With the operator in the seat of the loader,
the seat belt fastened and the seat bar
lowered (if so equipped), start the engine.
3. Raise the attachment slightly off the ground.
4. Engage the auxiliary hydraulics, turn on the 12V
connector switch, and push the POWER button
on the controller. The green LED will blink
rapidly (3 times per second) to indicate that
communication has been established.
NOTE:
If green LED blinks slowly (once per
second), or if red LED is blinking, see
“Troubleshooting” (pg. 33-34).
The tree spade can now be operated using the
electric controller.
NOTE: The loader should be run at about half-
throttle when operating the tree spade. Operating
the tree spade while the loader is at full throttle may
overload the valve and cause the attachment to
function improperly.