10
3BA00253-01
•
2021-05-17
•
Rev. 1
Ersa i-CON 1V & i-CON 1VC
6.
Troubleshooting
6.1
General errors
If the soldering station is not working as expected, please check the following points:
• Is line voltage available? Properly connect the power cord to the
equipment and the power point.
•
Is the fuse defective? The fuse is located on the back of the equip
-
ment in the mains connection socket.
•
Please observe that a defective fuse may also indicate a deeper
cause of failure. Simply changing the fuse is, therefore, generally not
sufficient.
• Is the soldering tool properly connected to the supply unit?
6.2
Error messages
The i-CON 1V carries out fault diagnoses independently.
The result of a diagnosis is output as an error code: In this
case, the triangular pictogram
①
appears in the display
of the soldering station. The error code
②
is shown as a
number between 2 and 99.
An info note
❸
is also displayed in the bottom line. For error codes, please refer to the
error code table in the operating instructions. Error messages must be acknowledged
through the i-OP. The connected soldering tool will be heated again only after the error
has been acknowledged and eliminated.
Troubleshooting
