Erreka ULS3C, Быстрое руководство по установке и программированию

Страница: 12 / 60

12
DIP Modes and functions Option Effect
DIP1 OFF
DIP2 Advance warning
ON the flashing light comes on and the operation begins after a 3
second warning
OFF the flashing light comes on and the operation begins
immediately
DIP3 Key commands using ST1 and ST2
ON ST1: opening command; ST2: closing command
OFF ST1: opening and closing commands; ST2: no function
DIP4 Automatic or step-by-step mode
ON automatic mode (the barrier closes automatically once standby
time has passed, adjusted using T.E.)
OFF step-by-step mode (the barrier only closes when receiving the
key command)
DIP5
Automatic mode optional
(only if DIP4 = ON)
ON during standby, the barrier obeys the key commands (can be
closed before standby time finishes)
OFF the barrier cannot be closed until standby time finishes; key
commands will cause standby time to restart
DIP6 Opening photocell testing
ON testing enabled
OFF testing disabled
DIP7 Encoder
ON encoder enabled
OFF encoder disabled
DIP8 Interlocking mode (with FT1)
ON interlocking mode enabled: the barrier closes if SG.C is enabled
during standby time (in automatic mode)
OFF interlocking mode disabled
DIP9 Closing photocell testing
ON testing enabled
OFF testing disabled
DIP10 No function always place in OFF
Function and mode selection using SW2 (DIP1 = OFF)
T.LG: fan operation time
Regulate the time the operator cooling fan is working.
• Minimum value: 3 seconds; maximum value: 90
seconds
T.E: barrier open standby time
If automatic or optional automatic operation mode has
been programmed, adjust T.E. to set standby time with
the barrier open (before starting to close automatically).
• Minimum value: 0 seconds; maximum value: 90
seconds
P.M: motor torque
Use P.M. to adjust the maximum motor power value.

Torque adjustment, respecting the maximum
closing forces set out in Standard EN12453:2000.
Make the measurements as described in Standard
EN 12445:2000.
Potentiometer adjustment