13
KM1800: Total opening radio code programming (with RSD receiver only)
If a receiver other than RSD is used,
see the corresponding instructions.
1
Connect the electrical power
supply and close the gate by keeping
PUL1 pressed down.
2
Select the code in the transmitter.
3
Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming mode
enabled.
4
Press the button of the required
channel. DL2 flashes to show
programming is complete.
5
Place DIP1 and DIP4 in OFF.
DL3 remains off.
6
Disconnect and reconnect the
electrical power supply.
Programming is carried out in the
same way, using DIP6 instead of DIP4.
PUL1
R160B
R160E
Pedestrian opening radio
code
KM1800: total open/close programming
1
Connect the electrical power supply
and close the gate by keeping PUL1
pressed down.
2
Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3 lights up to show programming
mode enabled.
3
Press ST1 to start opening.
4
Wait for it to come to a stop at the
end of travel.
5
Press ST1 to start closing.
6
Wait for it to come to a stop at the
end of travel.
7
Place DIP1 and DIP2 in OFF. DL3
remains off.
PUL1
G160Z
ST1
ST1
R160E
KM1800: pedestrian open/close programming
This is carried out in the same way as total travel
programming, with the following differences:
•
DIP1 and DIP3 are used instead of DIP1 and DIP2
•
ST2 is used instead of ST1
•
In step 4, stop the gate with ST2
