7
2.3
Connect Alarm I/O
The camera supports one alarm input and one relay output for alarm application.
Refer to section
Connectors
for pin definitions.
NOTE:
Do
NOT
connect external power supply to the alarm I/O
connector of the IP camera.
2.4
Camera Installation
The following description demonstrates how to directly install the camera to the
ceiling or to the wall.
NOTE:
This camera must be installed by qualified personnel and the
installation should conform to all local codes.
Step 1:
Loosen the two security screws on the camera
with the supplied security torx and open the
dome cover.
Step 2:
Open the back conduit entry block using a coin
and place it to the side conduit entry.
Step 3:
Place the camera at the installation location.
Mark the position of the two screw holes and
the back conduit entry (for cable entry use)
indicated in the right figure on the ceiling/wall.
