Use and maintenance manual
Auto-Puncher for timing belts
Model: APTM-600
____________________________________________________________________________________________________________________
P a g . 9
1.
RESET
This must be pressed after an emergency stop or position the head at the starting point
after STOP.
2.
A-A
Selection of the A-A program
This program is used in most cases, to always operate on guide rail and cut the belts
performing the first end by inserting it on one side of the bridge and the second end on the
other side, or to cut series continuously.
3.
A-B
Selection of the A-B program to do individual operations.
4.
STOP
Allows the cutting process to be halted at any moment, to change the time or cutting
pressure, for example.
On pressing START, it will continue the process without losing the positioning memory.
5.
START
Starts the cutting process or acts to reboot following a stop.
6.
MENU
This button is to jump from one programming field to another and thus amend the values:
Belt width
Step
Cutting time
7.
+ / -
To increase or decrease the marked field values.
8.
OK
To validate the modified value. Any modification must always be validated.
