6
7. Select machining mode with the selector [W
3
] to punching; punching is not
allowed in the profiling position;
8. Press pedal [W
2
] to initiate punching holes;
9. Continue the punching process until the sensor [W
6
] lights – (erratic running);
10. After the hole has been punched, depress pedal [W
2
] and the punch will
return to its initial position.
Fig. 1 and Fig. 2 illustrate particular elements.
Profiling
1. Insert the pin [11] and the profiling insertion [12];
2. Set the punching and profiling segment [2] with the use of the crank [6] so the
middle part of the profiling bar was positioned with the segment servo-motor
axis [2];
3. Set a required profiling angle at the scale [13] by releasing and clamping [14];
4. Start the machine [W
1
];
5. Select machining mode with the selector [W
3
] to profiling;
6. Press pedal [W
2
] to initiate profiling action;
7. Continue the profiling process until the extreme position selector [W
4
] lights –
(erratic running);
9. After the bar has been profiled, depress pedal [W
2
] and the profiling insertion
[12] will return to its initial position.
Fig. 1 and Fig. 3 illustrate particular elements.
Offsetting
1. Fit the offsetting insertion [17];
2. Set the punching and profiling segment [2] with the use of the crank [6] so the
middle part of the profiling bar was positioned with the segment servo-motor
axis [2];
3. Start the machine [W
1
];
4. Select machining mode with the selector [W
3
] to profiling;
5. Press pedal [W
2
] to initiate profiling action;
6. Continue the profiling process until the bar has been profiled;
7. After the bar has been profiled, depress pedal [W
2
] and the profiling insertion
[12] will return to its initial position.
Note: the offsetting insertion is not equipped with a run cycle switch. Offsetting
should be carried out only on the oval elements of the insertion. Prevent the bar
from pressing the flat element of the insertion.
Fig. 1 and Fig. 4 illustrate particular elements.
Working with an external die
1. Fit the external conductor [3] with a required die and fittings;
2. Start the machine [W
1
];
3. Select machining mode with the selector [W
3
] to external die;
ERKO company reserves the right to technical changes improving/modernizing its products.
