# VHG200020614
- 10 -
Fig. 19. Fig. 20.
Note:
When the bending insert is replaced with a different one, it is to be
parameterised with the station software ("INSERT CALIBRATION" fig. 20). To do this,
please contact the ERKO authorized service.
5.3 CUTTING
To proceed with the cutting process:
Start the station in accordance with the procedure set out in item 5.1.
Go to the cutting mode (fig. 7) or during normal operation press the CUTTING
button at the bottom of the screen (fig.8). The cutting mode screen is shown
in figure 21.
Insert a busbar into the working space.
Determine the distance from the cutting edge to the knife axis with the scale
engraved on the table top.
Press and hold the foot switch (Q3) to start the cutting cycle. When the
operation is finished, the piston rod returns automatically to the initial position.
To repeat the operation, release the foot switch and press it again.
Releasing the foot switch during the cycle results in the operation interruption
and return movement of the piston rod to the start position (performance of
the next cutting is only possible after the piston rod returns to the start
position).
