Erie 2400TS Series, Техническое руководство, Страница: 12 / 31

2400TS SERIES
Erie Water Treatment Controls – Belgium
Page 10
Programming
!!! ATTENTION
 During programming, it is necessary to enter the desired change within 60 sec. Otherwise the microprocessor
will automatically break off the programming and return to the service mode,
while all possibly entered
changes to the program are lost . If this occurs, it will be necessary to re-initiate the programming process.
 All programming parameters are grouped into different user-specific levels (End-User / Parameter Set /
Diagnostics). The end-user level is accessible freely; in order to access one of the other specific levels, the
proper access code, i.e. key sequence, needs to be entered.
 In the programming modes, a flashing indication implicates that this parameter can be adjusted by pushing the
up button or down button; in this technical manual this is indicated by means of an italic font.
Programming instructions for the End-User level
The basic configuration of the unit has been pre-programmed; the End-User level allows the end-user to rapidly
program the operating parameters, according to his own specific situation.
 Make sure that the control valve is in the service mode.
 Push the scroll button; the display will show:

Push the up button or down button to set the time of day .
 Push the scroll button again; the display will show:
 Push the up button or down button to set the number of days between regenerations .
 Push the scroll button again; the display will show:
 If the control valve is left in this position, the countdown timer will countdown to 0 sec and start a
regeneration .
 To cancel this mode, push the scroll button before the countdown timer has reached 0 sec; the control
valve will return to the service mode.
Regen in 10 sec
Set time: 20:51
Interval:XX Days