Ericsson SVP 2000, Справочное руководство, Страница: 43 / 196

Getting Started
3.6 Setting the Unit IP Address
Setting the IP address of a unit is accomplished using the web interface menus.
To set the IP address of the unit(s):
1. Ensure the unit is fully powered up and unit initialisation is complete.
2. Using the web interface, navigate to the Advanced, Network tab.
3. Set the required IP address settings for Adaptors 0 and 1.
4. Press the Apply button to accept the changes (Note that this change may result
in the unit being on an unreachable network from the control PC)
IP addresses on the unit must adhere to the range of restrictions specified in
RFC3330.
Table 3.2 RF C3330 IP Address Restrictions
Block Present Use Reference
0.0.0.0/8 This Network [RFC1700, p4]
10.0.0.0/8 Private-Use Networks [RFC1918]
14.0.0.0/8 Public-Data Networks [RFC1700, p181]
24.0.0.0/8 Cable Television Networks ---
39.0.0.0/8 Reserved but subject to allocation [RFC1797]
127.0.0.0/8 Loopback [RFC1700, p5]
128.0.0.0/16 Reserved but subject to allocation ---
169.254.0.0/16 Link Local ---
172.16.0.0/12 Private-Use Networks [RFC1918]
191.255.0.0/16 Reserved but subject to allocation ---
192.0.0.0/24 Reserved but subject to allocation ---
192.0.2.0/24 Test-Net ---
192.88.99.0/24 6to4 Relay Anycast [RFC3068]
192.168.0.0/16 Private-Use Networks [RFC1918]
198.18.0.0/15 Network Interconnect Unit Benchmark Testing [RFC2544]
223.255.255.0/24 Reserved but subject to allocation ---
224.0.0.0/4 Multicast [RFC3171]
240.0.0.0/4 Reserved for Future Use [RFC1700, p4]
EN/LZT 790 0046/1 R1A 3-9