Ericsson LBI-38901B, Руководство по установке

Страница: 17 / 36

20
Ignition Sense (All Applications)
NOTE
•
The radio as shipped from the factory has the "ignition sense"
feature disabled. As such the radio will be powered ON or OFF as
determined by the front panel ON/OFF/VOLUME control only
(assuming A+ and A- are connected). If it is desired to enable the
"ignition sense" feature, open top cover of radio and remove shield
from logic PWB. Slide switch SW601 from position 3-2 to 1-2.
Replace shield and top cover. Be sure to apply correct torque to
screws holding top cover in place. See Maintenance Manual.
•
The "Accessory" point should drop to ZERO volts when cranking
the engine and return to +12 volts after the engine is started. If a
point is chosen that drops to a voltage between zero and +12 volts,
the radio may execute a power-up cycle several times during start
up. It is recommended that the terminal be measured with a
voltmeter to be sure it shuts off (goes to zero volts) during the
cranking of the engine.
The fuse holder must be attached to the yellow sense lead along with the
ring terminal as follows:
1. Cut the yellow sense lead approximately 6-12" from the end that
will be connected to the power source.
2. Strip the insulation from each end of the short lead and from the
end of the long lead at least 3/8".
3. Insert the stripped end of the long lead and one end of the short lead
into the narrow end of each fuse holder half.
4. Crimp the leads in the fuse holder halves with a crimping tool.
5. Insert the 3 amp fuse into one end of the fuse holder and join the
two fuse holder halves firmly together.
6. Attach the ring terminal to the end of the short lead and connect
this lead to the ignition "ON" sense point [preferably an
"Accessory" point (in the vehicle fuse panel) that is switched on
when the vehicle ignition switch is in the ACCESSORY and RUN
positions].
17
Figure 17 - EURO Front Mount Extended Option Accessory Cable
19B802554P12