Erica Synths Drum Sequencer, Руководство пользователя

Страница: 4 / 18

QUICK STRAT
The Techno System is plug and play! Connect the power connector cable, connect
the LINK module to mixing console or amplifier using 6,3mm cables (not supplied
with the Techno System), flip the power switch and start patching!
Note that you can use the internal mixers for mixing sounds, as well as send
individual drums to the mixing console via LINK module.
In order to keep a setup more clean and easy to control, the system comes
internally patched with the Trigger and Accent cables leading from the Sequencer
to the modules, so you must take care only about audio and modulation patch.
Once a trigger is selected, a sequencer will indicate relevant drum voice on the
OLED screen. Nevertheless, you can still use patch cables for triggers and accents.
In that case internal patch will be interrupted and replaced by one with patchcables.
Also if you don't want to see trigger labels, but instead see the trigger channel
you can exit the "Techno System" mode by holding down 13,14,15,16 step keys
while booting up the system.
Internal connections and relevant representation on the screen are:
Please, refer to the patch examples below!
Mixer
or
amplifier
External
PSU
TR7 HI TOM HT
TR8 CLAP CP
TR9 CLOSED HAT CH
TR10 OPEN HAT OH
TR11 CRASH CYMBAL CR
TR12 RIDE CYMBAL RD
TR1 BASS DRUM BD
TR2 SNARE DRUM SD
TR3 SAMPLER 1 S1
TR4 SAMPLER 2 S2
TR5 LOW TOM LT
TR6 MID TOM MT