Ergon Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям, Страница: 85 / 176

Super Shot 125 DC 70CFM EU Part Manual
Chapter 8 Troubleshooting
©2022 by Crafco, Inc. All Rights Reserved
………………………………………………………...Troubleshooting (48300N) 8-9
Burner Ignition Coil Testing
Step Ignition Coil Test
1 Make sure the burner is off. Open the ignition transformer (located above the blower) to
expose the springs.
2 Check resistance between each of the springs and the ground (exposed metal on the burner).
3 The meter should read less than 2000 ohms. (Take note of the readings, you will use them in
Step 5.)
4 Check resistance between both springs. (Take note of the reading, you will use it in Step 5.)
5 The igniter should be replaced if:
•
The difference between the two springs to ground resistance readings is greater than 20%.
•
Or the spring-to-spring resistance does not read approximately twice the spring to ground.
Bleeding the Burner
This compressor unit is plumbed to have the burner be self-
priming. Ensure the “Main Power” and
“Burner” switch is “ON” and burner fuel pump will start circulating fuel through the fuel lines, which
removes all air bubbles automatically, since it has a return line to the fuel tank.
Table 8-10 Burner Ignition Coil Test