Ergon Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям, Страница: 64 / 176

Super Shot 125 DC 70CFM EU Part Manual
Chapter 6 Maintenance Instructions
©2022 by Crafco, Inc. All Rights Reserved
………………..………………………………..….…Maintenance Instructions 6-22
6.18 Flex Boom Adjustment
BOOM SWING
ADJUSTMENT NUT
GREASE ZERK
STOP BOLT
LOCKED POSITIONS
STRUT ADJUSTMENT
STRUT ADJUSTMENT
OUTER GUSSET
NOT SHOWN FOR CLARITY
Strut Adjustment
1. Remove the hose from both hose hangers and hose hook to lessen the weight on
the boom. Remove the stop bolt hardware, rotate the boom up to allow access to the
strut. The strut pin is removed by unclipping the clamp at the base of each end of the
strut and then pulling the pin out (the clamp is attached to the pin).
2. The factory set position on the strut is center hole on both ends of the strut. If you
desire less force lifting of the flex boom arm, you can move both ends of the strut to
the upper position. If you desire more force lifting the flex boom arm, you can move
both ends of the strut to the lower position.
Locked Position of the Flex Boom
1. If the strut wears out to the point that the strut no longer lifts the boom, you can move
the hardware in the stop bolt position to one of the two locked positions (different
boom height) to allow the crew to continue to work until a new strut can be installed.
Fig. 6-15 Flex Boom Adjustment