a
djUST
The
S
Topping
b
oLT
On the back side of your unit you will notice a small bolt located on the
lifting tower. This bolt is used as our work surface stopper. It is currently set
at 15”, the highest our unit should go. This setting is for a 6’2“ user on a 30”
high desk. If you are shorter than this, raise the unit to your desired height
and tighten the Main Brake. Adjust the stopping bolt by loosening the bolt
with one turn
and drop the bolt down to reach the lower support, and
re-tighten the stopping bolt.
If you are a taller individual and need to raise the stopping bolt, please note
that the work surface can get up to 16 1/2 inches but you will be raising the
unit into the oil dampening zone of the spring. This makes it a little more
difficult to lower the unit into the seated position when raised to this
maximum point.
Our work surface should only be raised to your belt or navel line. This creates
a 90-110 degree angle in your elbows which is suggested in the standing po-
sition. This will also allow you to lower the unit with ease by simply
transferring your upper body weight into the back of the unit.
T
he
S
TabiLizaTion
L
eg
Your adjustable height desk top unit comes with an adjustable leg that can be used
to give you maximum stability when you are using “The Kangaroo” in the standing
position.
Raise the Kangaroo work surface to your desired standing height and tighten the work
surface brake.
Place the adjustable leg under the work surface and loosen the adjustable leg brake.
Only loosen the brake by a turn or two, too much and the brake will disengage from
the slot.
Extend the adjustable leg until it engages the bottom of the work surface and then
tighten the adjustable leg brake.
The leg is shipped with the extension section installed to give you additional height
adjustment. If this is too tall for your application, simply unscrew the extension
selection.
always
remember
to
remove
the
stabilization
leg
before
lowering
your
work
surface
A
Extension selection
B
Screws into here
