Ercolina Top Bender 050, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 20

12
CML International S.p.A.
Spring back storage
It will be possible now to bend by continuing to press the button.
Once the bend angle will be achieved, the machine will stop automatically and the
yellow light will flash.
Press the
button to bring the machine back to the 0 origin point.
Completed memorised bend
SETTING C AXIS
Should the (0) position of the machine shaft be lost or offset it will be necessary to set
the machine in the shaft reset mode to bring the hexagonal shaft
(axis C) back in its
original position.
The shaft reset procedure can be accomplished as follows:
•
The machine shaft should be without any kind of tools;
•
Keeping the button or pressed by turning on the machine simultaneously,
you will enter the shaft reset mode.
•
When the mode is entered the display should show the following message:
Shaft (axis C) reset mode
In this mode press the or pedals, to move the hexagonal shaft base
aligned with the mark, placed on the aluminium body of the machine
itself.
•
To store the new origin or 0 point, you need to press the button and the
display will show as follows:
0
BEND 1 8° 090°
Mm 000.0 8° 000°
BEND 1 8° 090°
Mm 000.0 8° 090°
SHAFT RESET MODE