EASY-ROTOR-CONTROL M SMD V1.1
Instructions
___________________________________________________________________________
© Ing.-Büro E. Alba de Schmidt
web :
www.schmidt-alba.de
Tannenstr. 16
Page 23 of 32
email :
86836 Untermeitingen / Germany
This document is for the user only. Any publishing (printed or in electronic form) is not allowed.
6.5 Cable to connect the HID to ERC-M
Cut 130mm from the flat-ribbon-cable and press the 2x8 pole connectors to both ends as shown in the
next picture.
Take care of the orientation of the connectors (red circle) and the position of the red wire.
Use a bench-vise to properly press the connectors to the flat-ribbon-cable.
Those connectors are quite sensible and may damage if you don’t press
them properly.
Bend the flat-ribbon-cable on both ends over the top of the connector and put the strain-relief on.
6.6 Cable to connect the ERC-M to rear-side D-SUB
Take the remaining 200mm of the flat-ribbon-cable and remove 1 wire from the 16-pole cable to get a
15-pole cable (don’t remove the red wire, take the opposite site)
Press the 2 DSUB-connectors to both ends as shown in the next picture. The red wire always has to
show to pin 1 of the connectors. The pin-number of the connectors is printed in the plastics of the
connectors.
Red wire on this side
Red wire on this side
Pin 1
Pin 1
male
female
