13
12
02
UNPACKING
Unpack all parts and lay them on a flat, stable surface.
•
Remove all packing materials and shipping devices, if applicable.
•
Make sure the delivery contents are complete and free of any damage. If you find that parts
are missing or show damage do not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to people and property.
•
Ensure that you have all the accessories and tools needed for assembly and operation. This
also includes suitable personal protective equipment
WARNING!
The product and the packaging are not children’s toys!
Children must not play with plastic bags, sheets and small parts! There is a
danger of choking and suffocation!
03
ASSEMBLING THE MACHINE
CHARGING YOUR BATTERY PACK
The battery has been shipped in a low charge condition. Charge it fully before first use.
Refer to the charger instruction manual for the details.
TO REMOVE OR INSTALL THE BATTERY PACK (A1, A2)
Depress the battery pack release button to release and slide the battery pack out from your tool.
After recharge, slide it back into your tool. A simple push and slight pressure will be sufficient.
BATTERY PACK POWER BAR
The Li-Ion battery pack (7) is equipped with a POWER BAR which is used to give an
indication of the battery pack’s remaining charge. Press the POWER BAR button (8) to
check battery charge as below. The LED will stay lit for approximately 5 seconds
.
8
76-100% Charge
51-75% Charge
26-50% Charge
5-25% Charge
under 5% Charge
Flash
On
Off
USE
01
INTENDED USE
This product is a cordless torch. It is intended for use as illumination in dim or dark
working areas. Use the product in a dry environment only
02
OPERATION
ON/ OFF SWITCH (B)
Press ON/OFF switch button (6) to turn on the torch to maximum luminance.
Press ON/OFF switch button (6) again to turn on the torch to minimum luminance.
To turn it off, press the ON/OFF switch button (6) again
ADJUSTING THE TORCH HEAD (C)
Rotatable torch head (2) can adjust light direction to suit your working situation. The
rotary range is 0°to 104°.
LOOP AND MAGNETS (D1, D2)
Using the hanging loop (3) and magnets (4), the torch can be placed in multiple locations
for ideal lighting.
WARNING!
When torch is hung by the loop and magnets, do not shake
the torch or object that it is hanging from. Do not hang the torch from any
electrical wires or anything that it is not secure. Personal injury or property
damage may occur.
Only use the loop and magnets for hanging the torch. Hanging anything
additional to the torch could lead to serious injury.
Do not use the magnets and loop to reach with or use the magnet and loop
to support your weight in any situation..
1. Loop (D1)
The torch is equipped with a loop (3). It can be carried or hung to an object with the loop.
2. Magnets (D2)
Fix torch to ferromagnetic area by magnets (4) if required.
