8. Disposal of an exhausted battery pack
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your
local waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating your
lamp, then remove the battery pack from the lamp
housing and cover the battery pack connections
with heavy duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to
open or remove any of the components.
WORKING HINTS FOR YOUR
WORKING LAMP
1. The bulb is dim or not working when I
turn on the switch, why?
If the battery is not fully charged, recharge the
battery with the battery charger, which type is
supplied (Note: Do not charge the battery with a
different type charger). Also check if the bulb you
used is correct, if not; replace it with a correct one
following the instructions in this manual.
Warning:
The bulb become hot when used,
it could be hurt your finger. Turn off the
switch let your lamp cool for several minutes and
ensure the bulb becomes cool before you check
the bulb.
2. Reasons for different charging times.
Your charge time can be affected by many
reasons which are not defects in your product. If
the battery pack is only partly discharged it may
be re-charged in less than 1 hour. If the battery
pack and ambient temperature are very cold then
re-charging may take 1-1.5 hours. If the battery
pack is very hot it will not re-charge because the
internal temperature safety cut-out will prevent it.
If the battery pack is very hot you must remove
your battery pack from the charger and allow your
battery pack to cool first to ambient temperature
and then recharging can be started. If you charge
a second battery pack immediately after the first
then the charger can be overheated. Always allow
at least 15 minutes rest between battery pack
charging.
