Erbauer ERB8DLC, Руководство пользователя

Страница: 8 / 16

ASSEMBLY
Caution:
During use it is important not to
overload the grinder. The grinder should
run at close to full speed. If you are applying
too much pressure, the grinder will start to slow
down. Under these conditions, remove the part
being ground and allow the grinder to return to
full speed. Re-apply the part to the grinder, but
with a little less force.
All of the grinders are supplied with grinding
wheels designed for metal use only. The grinding
of Copper, Brass, Aluminum, Wood or other
similar materials will “clog” the grinding wheel.
Important:
Remove the plug from the socket
before assembly or carrying out any adjustment,
servicing and maintenance.
1. Fitting and adjusting the eye shields (See
Fig1, 2, 3)
Note. Always ensure the eye shields are correctly
fitted each time before the grinder is used. Eye
shields must be fitted over each grinding wheel
on all bench grinders in the range.
Install the eye shield as shown in Fig 2 & 3.
Fit the screw with a spanner through each side
of the eye shield into the pivot points and tighten
firmly to the point where the shield is secure.
2. Fitting and adjusting the spark deflectors
(See Fig 4)
Insert the screw through the spark deflector slot
and fix onto the wheel guard with a screwdriver
(not supplied).
To adjust the spark deflector, loosen the screw
and slide the deflector up or down. Make sure
that the bottom edge is less than 2mm from the
surface of the wheel, but not touching the wheel.
Rotate the wheel by hand one full rotation to
ensure the wheel can rotate without contacting
the spark deflector. Firmly tighten the screw
retaining the spark deflector.
Fig 2
Fig 1
Fig 3
Fig 4