Erbauer ERB575DRH, Оригинальное руководство пользователя

Страница: 16 / 20

8. DUST COVER (See Fig. 5)
Use the dust cover to prevent dust from falling over
the tool and on your self when performing overhead
drilling operations. Attach the dust cover to the bit as
shown in the K.
9. LUBRICATION MACHINE (See Fig. 6)
The machine is grease-lubricated. A grease refill is only
required during hammer work efficiency is low. Open
the grease box lid at the top of the hammer using the
pin spanner provided. Then refill approx 30g grease
provided with your tool. The grease specification
is general purpose lithium based. Use only Worx
genuine hammer grease (optional accessory).
CHISEL FUNCTION
1) For chipping, grooving or demolition operation,
press the lock button (A) and then rotate the
selector switch make sign “ “ pointing to the
triangle.
2) Turn the hammer or drilling action selector switch
pointing to the hammer action “ “ position.
3)You are now set up for chisel work using Chisel
action.
NO FUNCTION MODE:
1) Rotate the selector switch make sign “ “ pointing
to the triangle.
2) Turn the hammer or drilling action selector
switch pointing to the drilling action “ “ position.
3) The motor turns without load, the shaft will not
turn.
Warning! Do not set the switch like this. It may
damage the motor greatly.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
A
Warning: You must make sure that the selector switch is positively locked in chisel mode
position. If not, it could cause a hazard.
A
A