Erbauer ERB561SRG, Руководство пользователя

Страница: 17 / 24

700W HVLP SPRAY GUN ERBAUER
> Empty all paint from the cup (18) by pouring
it into another container. Thoroughly clean
the cup (18) with a suitable cleaning agent,
which does not contain oil.
> Fill cleaning agent into the cup (18), switch
on the product and spray it through the
spray head (20) until the cleaning agent
exits as a clear, transparent mist.
> Switch off the product, disconnect it from the
power supply and remove the cup (18) from
the spray gun (Fig. 12).
> Remove the attached pipes (19a, 19b) from
the lid (19) and disassemble the lower
suction pipe (19b) from the upper suction
pipe (19a) by releasing the locking pins (19c)
from the grooves (19d) (Fig. 13).
> Disassemble the spray head (20) by
removing the O-ring (23) and the spray
nozzle (22) (Fig. 14).
> Carefully clean all the disassembled parts
with a cleaning agent. Use a cleaning
needle (25) to remove any paint residue
from the nozzle hole (Fig. 15).
> Reassemble the product. If the product is not
used for a longer time, add lubricant to the
needle and connect the product to the power
supply, switch it on and operate it for a
moment.
> Attention:
- Never use aggressive solvents for cleaning.
- Never use hard materials like wire, wood,
screw drivers etc. or abrasive agents for
cleaning.
- Never submerge the product in cleaning
agent.
- To store the product, attach the cup (18) to
the spray gun.
> Turn the fluid adjustment knob (16)
anticlockwise to open which will reduce
spring tension on the needle fluid tip.
6. Air filter
This product is supplied with two air filter
cases on each side of the main body.
Inspect the air filter regularly. Replace it
with a new one if necessary.
2
18
Fig. 12
1
2
19b
19d
19c
19a
19
Fig. 13
22
23
20
2
1
Fig. 14
25
Fig. 15