Erbauer ERB406, Руководство пользователя

Страница: 9 / 16

1
/
2
SHEET SANDER
OPERATING INSTRUCTIONS
1. ON/OFF SWITCH
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON
Depress on/off switch (1) then lock on button (2)
(See Fig 1), release on/off switch first and lock
on button second. Your switch is now locked on
for continuous use. To switch off your tool just
depress and release the on/off switch.
3. VARIBLE SPEED CONTROL DIAL
Adjust the dial to increase or decrease the speed
according to the material and sanding sheet
specification to be used (also possible during no
load operation) (See Fig 1). Avoid prolonged use
at very low speed as this may damage your sander’s
motor.
4. HAND GRIP AREA
You can operate your sander with two hands (See
Fig 2).
5. CHANGING STANDARD SANDING PAPER
To remove the sanding paper, lift up the clamp
lever (8) and move away from the clamp lever lock
(9) (See Fig 3.1). The sanding paper clamp (6) is
now loose. Repeat with the other clamp on the
opposite side of your sander. To fit new sanding
paper, insert approximately 5mm of one end of
the sanding paper under the sanding paper clamp
(6) until the paper contacts the housing wall (See
Fig 3.2). Lift up the clamp lever (7) and move it
to the lever lock position. Press the sanding
paper around the baseplate shape as tight as
possible and fix the end under the other sanding
paper clamp (6). Check the sanding paper is square
to the baseplate and remove and refit it if not
correct. Always, ensure the sanding paper is
tight over the baseplate and secured underneath
both locked clamps (6). This will ensure safe and
efficient sanding performance.
6. PAPER PUNCH
If using sanding paper without dust holes, use
the paper punch to perforate the holes to ensure
correct dust extraction. Position the punch (10)
over the baseplate (5) with the punch sides on the
edges of the baseplate (See Fig 4). Press the punch
Fig 1
Fig 2
Fig 3.1
Fig 3.2
SFX-ERB406-M-050608.indd 9 2005-6-8 14:49:58