Erbauer ERB401SDR, Оригинальное руководство пользователя

Страница: 14 / 20

360W 1/2 SHEET SANDER 360W 1/2 SHEET SANDER
Derusting
metal
40 120 9800~11000
Sanding
metal and
steel
120 240 9800~11000
Sanding
plexiglass
180 400 6500~8700
4. HAND GRIP AREA
You can operate your sander with two hands (See
Fig. 2).
5. CHANGING STANDARD SANDING PAPER
To remove the sanding paper, lift up the clamp lever
and move away from the clamp lever lock (See Fig.
3-1). The sanding paper clamp is now loose. Repeat
with the other clamp on the opposite side of your
sander. To fit new sanding paper, insert approximately
5mm of one end of the sanding paper under the
sanding paper clamp until the paper contacts the
housing wall (See Fig. 3-2). Lift up the clamp lever
and move it to the lever lock position. Press the
sanding paper around the base plate shape as tight
as possible and fix the end under the other sanding
paper clamp. Check the sanding paper is square
to the baseplate .If not correct, remove and refit it
again. Always, ensure the sanding paper is tight over
the baseplate and secured underneath both locked
clamps. This will ensure safe and efficient sanding
performance.
6. PAPER PUNCH
If using sanding paper without dust holes, use the
paper punch to perforate the holes to ensure correct
dust extraction. Position the punch (10) over the
baseplate with the punch sides on the edges of
the baseplate (See Fig. 4). Press the punch into the
baseplate to punch holes into the sanding paper.
Then remove the punch and check all the holes have
been formed correctly.
7. DUST BAG
Always operate your sander with the dust box fitted.
To remove the box, slide the mounting bracket out
and away from the sander (See Fig.5-1) then empty
the dust by zipping the bag.. (See Fig. 5-2). For the
best performance always empty the dust box when
it is half full. To refit the bag, firmly push the mounting
fig. 2
fig. 3-1
fig. 3-2
fig. 4
2
1 +
-
3
2
1 +
-
3
2
1 +
-
3
2
1 +
-
3