Erbauer ERB239MSW, Оригинальное руководство пользователя

Страница: 23 / 40

ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
3. Bevel pointer adjustment
1) When the blade is exactly 90
°
(0
°
) to the table,
loosen the bevel indicator screw (1) using a #2 Phillips
screwdriver.
2) Adjust bevel indicator (2) to the “0
°
” mark on the
bevel scale and retighten the screw. (See fig. 20)
4. Bevel adjustment 45° Right or Left
1) Loosen the bevel lock handle (1) and tilt the cutting
head completely to the left.
2) Using a combination square, check to see if the
blade angle is 45° to the table.
3) If the blade is not at 45° to the mitre table, tilt the
cutting arm to the right, loosen the locknut (2) on the
bevel angle adjustment bolt (3) and use an allen key to
adjust the stop bolt (3) depth in or out to increase or
decrease the bevel angle.
4) Tilt the cutting arm to the left to 45° bevel and
recheck for alignment.
5) Repeat steps 1 through 4 until the blade is at 45° to
the mitre table.
6) Tighten bevel lock handle (1) and locknut (2) when
alignment is achieved
.
7) Repeat the above procedure but tilt the cutting head
completely to the right.
(See fig. 21)
5. Bevel Setting for Crown Moulding
The cutting arm can also be set at 33.9
0
right or left for
cutting crown mouldings.
1) Twist and deploy sprung-loaded crown moulding
pin (2).
2) Loosen the bevel lock handle
(1) and rotate the
cutting head in the required direction until it indexes
with the moulding pin (2). Tighten the bevel lock. (See
fig. 22)
6. Bevel adjustment 33.9
o
If necessary the 33.9
°
settings can be checked and
adjusted. A vernier angle gauge will be required and
this must be accurately set to 33.9
°
1) Set the cutting head to 33.9
°
(RH) by deploying the
crown moulding pin. Check the angle of the blade
against the machine table using the vernier angle
gauge. (See fig. 23)
Fig 20
Fig 21
Fig 22
1
2
1
2
3
2
3
1
2
3
4
3