Erbauer ERB150D, Инструкция по эксплуатации, Страница: 11 / 16

18kg BREAKER
operation (see fig5), To switch off just release the
on/off switch.
GEARBOX MAINTENANCE
Always check there is sufficient grease in the
grease box before usage. Check every 5 hrs of
usage.
Open the grease box using the Hexagon key
provided, as shown fig6. Top up the gear.
CHANGE THE CARBON BRUSH
Replace when the Carbon brush wear down to
length of about 6mm or less.
Warning!
These carbon brushes should be
replaced by a qualified service engineer
carbon brush should be replaced in pairs.
Remove the covers for carbon brush. (as shown
fig7 & fig8)
MAINTENANCE
1. Your power tool requires no additional
lubrication or maintenance.
2. There are no user serviceable parts in your
power tool.
3. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
4. Always store your power tool in a dry place.
5. Keep the motor ventilation slots clean.
6. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.
HANDY HINTS
Always use sharp good quality chisels. The
performance of the drill is dependent on the
quality of the bits used.
• Reduce the pressure on the drill bit when it is
about to break through.
• Always operate tool using both the handle and
the front handle.
• Make sure that you wear safety glasses and
protective gloves.
• Do not apply excessive pressure to the tool.
Expressive force does not speed up the work.
Fig 6
Fig 7
Fig 8