Erbauer ERB150D, Инструкция по эксплуатации, Страница: 10 / 16

1
2
Loosen
Tidhten
GENERAL DESCRIPTION
The concrete breaker and pick can be cut
crushing asphalt, grooving and squaring, ram
tamping sand and gravel, dig ground in various
foundation, etc. The machine uses a single
phase alternating current 230V, 50Hz motor, its
compact and robust format makes it versatile
and efficient for uses described in specific safety
instructions. It complies to current regulations
and the optimum quality of materials used will
ensure a long working life in complete safety.
OPERATION INSTRUCTIONS
Familiarise yourself with the breaker before use.
Make sure the breaker is isolated from the mains
supply before fitting accessories. Sometimes the
tool does not begin the striking stroke even when
the motor rotates because the oil (grease) has
become thick.
Note:
If the tool is used at low temperature or if
it is used after a long time idle, the tool should
be used running in for five minutes in order to
warm it up.
RUBBER PROTECTOR
(See fig2)
Before chiseling vertically fit the rubber protector
over the drill bit.
Caution:
Always wear eye protection with
this tool.
FITTING THE CHISEL
(as shown fig3)
1. Insert the chisel into the chunk.
2. Drag the stop lever and rotate it to “Lock”
position.
REMOVE THE CHISEL
(as shown fig3)
1. Drag the stop lever and rotate it to “Unlock”
position.
2. Remove the chisel.
FITTING THE AUXILIARY HANDLE
Attached the handle as shown in fig4.
OPERATING THE LOCK-ON SWITCH
Holding the Breaker with both hands and depress
the on/off switch then lock on button in for
Fig 5
Fig 2
Fig 3
Fig 4