Erbauer ERB109SDR, Руководство пользователя, Страница: 13 / 17

900W BELT SANDER
8. DRIVE BELT (SOLD SEPARATELY)
REPLACEMENT (See Fig I, J)
WARNING! Remove the main plug
from the socket before carrying out
a drive belt replacement. Do not attempt
to remove the drive belt until the belt
wheel has cooled down.
Remove the screws (A) and the belt cover.
Carefully cut the drive belt if not already broken
and remove from your belt sander. Fit your new
drive belt around the large pulley. Then install
onto the small pulley by rotating clockwise and
pushing the drive belt shown around the small
pulley at the same time. The drive belt will be a
tight fit. Fit the belt cover and the screws.
9. CARBON BRUSHES
(SOLD SEPARATELY) REPLACEMENT
(See Fig K)
Remove and check the carbon brushes regularly.
When they are worn to length of about 6mm,
both new carbon brushes should be replaced
at the same time. When changing worn carbon
brushes, use a slotted screwdriver to remove
the brush holder caps. Take out the worn carbon
brushes, insert the new ones and make sure
the carbon brushes moving freely in the brush
holders. Finally, secure the brush holder caps.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run with no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speed. Always use a sanding belt
suited to the material you wish to sand. Always
ensure the work-piece is firmly held or clamped
to prevent movement. Support large panels
close to the sanding area. Any movement of the
material may affect the quality of the sanding
finish. Start your sander before sanding and turn
off only after stopping sanding. For best results,
sand wood in the direction of the grain. Do not
start sanding without the sanding belt fitted.
Empty the dust bag every 5 minutes or sooner to
ensure efficient dust collection.
Fig I
Fig J
Fig K
A