Erbauer ERB107SDR, Инструкция по эксплуатации

Страница: 12 / 20

OPeratIOn
NOTE:
Before using the tool, read the
instruction book carefully.
1. fITTINg THE SANDINg PAPER (SEE fIg
A, b & C)
To fit the sanding paper, lift up the clamp lever
(4) and move away from the clamp lever lock .
The sanding paper clamp is now loose. Repeat
with the other clamp on the opposite side of
your sander.
To fit new sanding paper, insert approximately
5mm of one end of the sanding paper under the
sanding paper clamp until the paper contacts the
housing wall. Lift up the clamp lever and move
it to the lever lock position. Press the sanding
paper around the base plate shape as tight as
possible and fix the end under the other sanding
paper clamp.
Check the sanding paper is square to the
baseplate. If not correct, remove and refit it
again. Always, ensure the sanding paper is tight
over the baseplate and secured underneath both
locked clamps. This will ensure safe and efficient
sanding performance.
fig A
fig b
fig C