Erbauer ERB096HTG, Руководство по эксплуатации

Страница: 6 / 20

ADDITIONAL SAFETY POINTS FOR YOUR HEAT GUN
1 Before connecting the unit to the mains - ensure the unit is switched OFF as it will
achieve maximum heat in just 60 seconds.
2 This unit reaches 650 Centigrade - always wear protective gloves and eyewear.
3 Always allow to cool before storing and never touch the heat deflector.
4 Never attempt to use the unit to dry animals, clothing or hair.
5 Do not expose the unit to rain or moisture.
6 ONLY use in well ventilated areas.
7 Heat may be transferred to combustible materials out of eyesight or close to the
working area.
8 When using this appliance in an area where there may be combustible materials or
gases, extreme caution must be taken to prevent fire or explosion. Do not apply to
the same place for a long time.
9 Do not apply the heat nozzle to an area for excessive periods of time.
10 A fire may arise if the heat gun is not used with care.
11 Do not use in presence of an explosive atmosphere.
12 Do not leave the heat gun unattended when in use.
13 If the supply cord is damaged, it must be replaced by a special assembly available
from a service agent.
14 This product is designed for light domestic use only, it is not designed for industrial
purposes and every care has been taken to make the heat gun safe, accidents can
happen. By following the simple safety guide, you can avoid serious accidents.
15 Do NOT store until the heat gun has fully cooled.
DO NOT BLOCK THE VENT AT THE REAR OF THE UNIT.
WARNING!
During application the heat nozzle must be kept at least 50mm (2inch) away
from the work piece. This is to allow air flow.
Do not touch the nozzle or the scraper blade when working.
These become extremely hot and will cause severe burns.
Wear gloves to protect hands from hot scrapings and heat resistant.
DOUBLE INSULATION
The tool is double insulated. This means that all the external metal parts are electri-
cally insulated from the mains power supply. This is done by placing insulation barri-
ers between the electrical and mechanical components making it unnecessary for the
tool to be earthed.
IMPORTANT NOTE
Be sure the supply is the same as the voltage given on the rating plate. The tool is fit-
ted with a two-core cable and plug.
Remove the mains plug from socket before carrying out any adjustment or servicing.