27
26
A sanding sheet that has been used for metal should not be used for other materials.
Use only original sanding accessories.
Scraping
The tool is suitable for scrapping and removing surface coverings. For scraping, select a
high speed setting.
To remove surface covers, place the scraping blade vertically on the work piece.
Switch the tool on and cut down through the covering.
Place the tool at a flat angle (not over 20°) and apply a light forward pressure to remove
the covering.
Plunge cut
WARNING!
Only plunge cut in soft materials such as plaster or wood!
Do not cut any hard materials such as steel and other ferrous metals!
This is suitable for cutting and plunge cuts, close to the edge sawing, sawing in corners
and confined spaces.
Use appropriate blades.
Mark the cutting line on the workpiece.
Turn on the tool and use light pressure in the direction of plunging.
Move the saw along the mark.
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem
Tool/ Battery Status Possible cause
Solution
Overload
protection
Product suddenly
Stops; The LED
work light (if fitted) is
flashing
Extremely high
torque, binding and
stalling situations,
overloading of the
tool
Relieve the load
immediately, reset the tool
by switching off and back on
again
Temperature
extremely
high
The first and the
third LED light of the
POWER BAR will be
flashing alternately
Battery
temperature
exceeds 77°C
during operation
Cool down the battery to
below 77°C for operation
and below 57°C for charging
Low charge
Power for the tool will
drop quickly; The first
LED on the POWER
BAR begins to flash
The battery pack is
under 5% charge
Remove the battery pack
from the tool and charge it
Other
problems
Short charges
Not fully charged
Make sure that the battery
is fully charged every time
by allowing the charger to
complete its full charging
cycle
Poor storage
condition
Always remove battery from
the tool and charger when
not in use and store in a dry
secure place. Avoid charging
or storing your battery in
temperatures below 5°C and
above 40°C. Cool down a
hot battery pack from a tool
that has just been operated
for approximately 30 minutes
before storage