Erbauer ECD18-Li-2, Оригинальное руководство пользователя

Страница: 13 / 17

25 24
AUTOMATIC LED WORK LIGHT (J)
The LED work light (9) will illuminate when the trigger switch is depressed slightly, and
will automatically turn off a short while after the trigger switch is released. This provides
additional light on the surface of the workpiece for operation in lower light situations.
WARNING!
Do not look directly into LED light.
DRILLING
When drilling into a hard smooth surface, use a centre punch to mark the desired hole
location. This will prevent the drill bit from slipping off centre as the hole is started. Hold the
tool firmly and place the tip of the bit at the point to be drilled. Depress the switch trigger to
start the tool. Move the drill bit into the workpiece, applying only enough pressure to keep
the bit rotating. Do not force or apply side pressure to elongate a hole.
WARNING!
Tungsten carbide drill bits should always be used for
concrete and masonry. When drilling in metal, only use HSS drill bits in
good condition. Always use a magnetic bit holder (not included) when using
short screwdriver bits. When screw-driving, apply a small quantity of liquid
soap or similar to the screw threads to ease insertion.
Where possible, secure smaller work pieces to prevent them from moving
during operation.
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem Tool/ Battery Status Possible cause Solution
Overload
protection
Product suddenly
Stops; The LED
work light (if fitted) is
flashing
Extremely high
torque, binding and
stalling situations,
overloading of the
tool
Relieve the load
immediately, reset the tool
by switching off and back
on again
Temperature
extremely high
The first and the
third LED light of the
POWER BAR will be
flashing alternately
Battery
temperature
exceeds 77°C
during operation
Cool down the battery to
below 77°C for operation
and below 57°C for charging
Low charge Power for the tool will
drop quickly; The first
LED on the POWER
BAR begins to flash
The battery pack is
under 5% charge
Remove the battery pack
from the tool and charge it
Other
problems
Short charges Not fully charged Make sure that the battery
is fully charged every time
by allowing the charger to
complete its full charging
cycle
Poor storage
condition
Always remove battery
from the tool and charger
when not in use and store
in a dry secure place. Avoid
charging or storing your
battery in temperatures
below 5°C and above 40°C.
Cool down a hot battery
pack from a tool that has
just been operated for
approximately 30 minutes
before storage