Erbauer 3663602796091, Оригинальное руководство пользователя

Страница: 21 / 32

Continuous mode
1. Switch the product on by pressing the on/off switch (2) and hold it in position.
2. Press the lock-on button (1) to lock the on/off switch (2).
3. Release both switches. The on/off switch (2) is now locked-on for continuous use.
4. Depress and release the on/off switch (2) to switch the product off.
02
Automatic LED work light
LED work light (20) will automatically illuminate the working zone when you press the
On/Off switch (2).
WARNING! Do not look directly into LED light!
03
Speed dial (Fig. G)
Limit the maximum speed using the speed dial (17).
1. Turn the speed dial (17) forward (as seen from the operator’s position) to increase
the speed. A higher setting is suitable for cutting with fine saw blades and soft
materials.
2. Turn the speed dial (17) backward (as seen from the operator’s position) to
decrease the speed. A lower setting is suitable for cutting with coarse saw blades
and hard materials.
1 2 3 4 5 6
Slow Medium Fast
hardwood, thick
workpieces
plywood, plastics, non-
ferrous metal, soft steel
soft, thin workpieces
Use
Intended use
This product is intended for cutting wood and similar material e. g. MDF and chipboard,
plastic and metal using appropriate saw blades.
The product must be used in an upright position only with the base plate lying flat on
the workpiece. It may not be used upside down or as stationary product on a work
bench.
The product must not be used on masonry and materials that are harmful to health.
Before you start
01
Protection
Controls
WARNING! Always switch the product off and disconnect it from power
supply before making any adjustments!
01
Switching on/off (Fig. G)
Operate the product either in instant or continuous mode.
Instant mode
Switch the product on by pressing the on/off switch (2). And release the trigger to stop
it.
21 20