30
Use
Intended use
The product is intended for longitudinal and plunge cutting on solid wood, wood-like
materials, metal and mineral materials (e.g. tiles) when equipped with appropriate saw
blades / diamond cutting wheels.
For safety reasons it is essential to read the entire instruction manual before first
operation and to observe all the instructions therein.
Before you start
01
Protection
Controls
WARNING!
Always switch the product off and disconnect it from
power supply before making any adjustments!
01
Adjusting cutting depth (Fig. C)
Always use the correct cutting depth setting! The correct blade depth setting for all
cuts should allow approx. 3 mm to be visible below the material being cut.
1. Open the depth clamping lever (9) by hand.
2. Raise/lower the depth clamping lever (9) and set the blade to the required depth
as shown on the cutting depth scale (11).
3. Lock the depth clamping lever (9).
02
Laser (Fig. I)
Use the laser as guide when cutting on marked lines.
1. Switch the laser on by pressing the laser on/off switch (15).
2. Switch the laser off by pressing the laser on/off switch (15) again.
WARNING!
Do not stare into the beam, class 2 laser product!
03
Switching on/off (Fig. J)
1. Shift the safety lock switch (3) backward to unlock the on/off switch (2).
2. Press the on/off switch (2) to switch the product on.
3. Release the on / off switch (2) to switch the product off.
04
Speed adjustment (Fig. K)
Adjust the speed depending on the application.
1. Turn the speed dial (21) left (as seen from operators position) to increase the
working speed.
2. Turn the speed dial (21) right (as seen from operators position) to decrease the
working speed.
650W Mini circular saw_MNL_EMCS650_TPS_GB_V02_V20518_20180604.indd 30
6/4/18 09:20
