28
02
Saw/diamond blade (Fig. A, B, C, D, E)
WARNING!
Always use blades according to the intended use! For
example, never use a saw blade intended for working on wood for
working on metal/tiles or vice versa!
Observe the technical specifications of this product and the saw/diamond
blades when purchasing and using blades!
Attachments are sharp and hot after use! Handle them with care! Wear
safety gloves when handling attachments to avoid injuries like burns and
cuts!
WARNING!
Never press the spindle locking button (19) whilst the
spindle is rotating!
Installation/Replacement
1. Press the spindle locking button (19) fully and hold it in position. (Fig. A)
2. Turn the clamping screw (7) slightly with the hex key (20) until the spindle is locked.
(Fig. B)
3. Loosen the clamping screw (7) clockwise and remove it together with the blade
clamping flange (8). (Fig. B)
4. Open the depth clamping lever (9), move it to the left end and lock the depth
clamping knob (9) afterwards. (Fig. C)
5. Shift the safety lock switch (3) backward (Fig. D step 1), raise the base plate (5)
fully to expose the blade (Fig. D step 2) and remove the blade from spindle if
applicable.
6. Keep the base plate raised as above while inserting a new saw/diamond blade into
the lower guard (5a) and then placing it on the spindle.
The direction-of-rotation arrow on the blade should comply with the one
on blade guard!
7. Fix the saw/diamond blade with the clamping flange (8) and clamping screw (7) by
turning it anti-clockwise while the spindle locking button (19) is pressed. (Fig. E)
8. Release the spindle locking button, remove the hex key and turn the saw/diamond
blade by hand to check if it rotates smoothly. The blade should not flutter.
9. Switch the product on and let it run at no-load speed for about one minute to
ensure that the saw/diamond blade has been installed properly. If there is any
abnormal vibration or excessive noise, switch the product off and re-fit the saw/
diamond blade according to the above instructions.
03
Parallel guide (Fig. F)
Attach the parallel guide to perform cuts parallel to the workpiece edges.
1. Loosen the parallel guide clamping bolt (18) anti-clockwise with the hex key (20)
(Fig. F step 1).
2. Align the parallel guide (6) with the two brackets and insert it through them (Fig. F
step 2).
3. Use the scale to adjust the desired width.
4. Secure the parallel guide (6) in position by tightening the parallel guide clamping
bolt (18) clockwise.
04
Replacing the batteries of laser (Fig. G)
1. Slide and open the cover of the laser battery compartment (10).
2. Insert 2 button cell batteries of type LR44H as indicated. Please pay attention to
the cell polarity marked on the housing.
3. Close the laser battery compartment (10) cover and slide to fix it in position.
05
Dust extraction (Fig. H)
WARNING!
Always attach a dust extraction device when using this
product to keep the working area clean!
Wear a dust mask when operating this product! Dust can be harmful to
health!
Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment
(Ø35mm) to the vacuum cleaner adaptor (16) and then attach to dust extraction outlet
(17).
650W Mini circular saw_MNL_EMCS650_TPS_GB_V02_V20518_20180604.indd 28
6/4/18 09:20
