23
22
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
PROBLEM
TOOL / BATTERY
STATUS
POSSIBLE
CAUSE
SOLUTION
Overload
protection
Product suddenly
stops
Extremely high
torque, binding and
stalling situations,
overloading of the
tool
Relieve the load immediately,
reset the tool by switching off
and back on again.
Temperature
extremely
high
The first and the
third LED light of the
POWER BAR will be
flashing altemately
Battery
temperature
exceeds 77°C
during operation
Cool down the battery to
below 77°C for operation and
below 57°C for charging.
Low charge
Power for the tool
will drop quickly;
The first LED on
the POWER BAR
begins to flash
The battery pack is
under 5% charge
Remove the battery pack
from the tool and charge it
Other
problems
Short charges
Not fully charged
Make sure that battery is
fully charged every time
by allowing the charger to
complete its full charging
cycle
Poor storage
condition
Always remove battery from
the tool and charger when
not in use and store in a dry
secure place.Avoid charging
of storing your battery in
temperatures below 5°C and
above 40°C. Cool down a
hot battery pack from a tool
that has just been operated
for approximately 30 minutes
before storage
CARE & MAINTENANCE
WARNING!
Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance and
cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
BLADE CLEANING AND LUBRICATING
WARNING!
Wear safety gloves when working on the cutting device and
close to it! Use appropriate tools to remove debris e.g. a brush or wooden
stick! Never use your bare hands!
Keep the blade (1) clean and free of debris. Remove trimmings.
Apply a small amount of suitable lubricant on the cutting device to retain a good cutting
performance.
Keep the blade (1) sharp. Only replace blade with a new one from authorised repairer.
Adjustment of the distance between blades is not necessary, as this is predetermined by
the manufacturer.
If the cutting device overheats during operation, it is necessary to lubricate the internal
surfaces of the blades (Fig. L).
CLEAN
• Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
• Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful to
its surfaces.
